Life in the Bow Seat

Just received this question from a reader:

Hi. I’m a novice oarsman. I’ve been rowing for about a semester and a half now, and until a few days ago I’ve been rowing portside. However, due to new arrangements, I just started rowing starboard in the bow. In the bow, I realized that I’ve been catching quite a few crabs due to the boat not being set whenever I row.
Is it usual for the bow to feel that way? It seemed like I had to push up the oar handle everytime I bring myself up to the catch. And this caused me a lot of trouble. Any suggestions?

Ahh . . . life in the bow seat. It can be a paradise, or a paradox.

What I mean by this is that often it seems that technical issues, especially one’s related to balance seem to magnify themselves in the bow seat. Whether this actually happens or not does not matter as much as it appears that they do. Especially to the person sitting in that seat!

There may actually be technical rowing issues here (especially if you have been rowing only a few months). However, from a mechanical/rigging perspective (which this site is about) I suggest you do some, if not all, of the following steps:

1. Relate to your coach the issue you just described
2. Have the rigging of your rigger checked, specifically the height
3. Realize that balance is a major component of rowing, and something that rowers, and boats filled with rowers, often struggle with this (hmm . . . patience)

I hope these help some, and that you get to the finish line first.

Measuring Rigger Height in a Rowing Shell (Basic Rigging Video)

The height of a shell’s rigger is important for two basic reasons: efficiency and comfort. When the height is right both of these components are maximized. When the height is off the rower will either be less efficient or uncomfortable, or both.

I recently wrote on how to do a super simple quick rigger-height check while on the water. The following video is about measuring the height while the boat is in slings (although it can be measured while the boat is seats down if you are adventurous).

The steps to measuring are simple, and so are the needed tools. You can go more advanced with tools, such as with the Active Tools rigging stick (which I like) but a basic tape measure and straight edge is really all you need.

Hope this video helps, and if you have questions or comments please leave them below.

Super-Simple Height Check for Your Shell’s Rigger

Recently Rob submitted this question:

Hi Mike,

I have a question regarding rigger heights. We are a men’s masters crew and as you would expect there is a wide variance in body shapes and sizes.

How would you set up the boat? Would you work on an average height or set up each individual rower?

For example our stoke is 6 ft 3 inches but the average height would be 5ft 10 inches. From my perspective I am 5 ft 9 with short legs and long body, so I sit quite high in the boat and find drawing up to my sternum at the finish difficult at times. Any assistance would be greatly appreciated.

Rob, good question. Here is what I suggest:

I would certainly have rigger heights set per the person, when you get to the stage of knowing who rows where. Easiest (and best) way is to do a height check when you first launch. Following are those steps:

• Have bow 4 set boat
• Stern 4 go to finish position, blades square in water
• Make sure that the blades are buried as you want the finish to be set
• The outside arm should be parallel to the surface of the water. If the wrist is above the elbow, probably too high. If the wrist below elbow, probably too low.
• Then have stern 4 set, and check the bow 4
• Adjust riggers accordingly, and take a test row.

Yes this sounds super simple, and for the most part it is.

Measuring your riggers in the boat bay works well but it doesn’t account for the crew’s average weight not being the same as the average weight that the builder made the boat to carry. This simple Height Check accounts for that and has proven itself over the year.

Good luck, and Row Slow!