Stern pitch is basically the angle the oarlock pin has towards the stern of the boat. Since most oarlocks today come with pitch in them we measure the stern pitch with the oarlock on the oarlock pin. This is done, measured, with a pitch meter.

There are many pitch meters available, and I plan on a review of some of those in a later post, but for this video I use a meter made by Bill Leavitt. Bill has made some very handy rigging tools and is a wonderful coach (since retired). If you have a chance to try one of his pitch meters, I suggest you take advantage of it. They are simple, and work well.

There are a few steps you should take before measuring to help you get the best readings:

1. Put the boat in a safe spot, in good slings, so not to worry about it falling over
2. Make sure the oarlock is clean and not worn
3. Take the measurements in a place where you have enough light, and space, to read the meter and move at your own pace.

I’ve measured the pitch in a wide variety of places, and even with the boat upside down. You can do that (although you probably don’t want to make a habit of it) and get a good reading but it takes a steady hand and experience. If you are just starting out find a quiet place that is has good light, and take your time. Double check your work.

You do not need to worry about the boat being level from bow to stern, it can be at an angle. But for accurate readings the boat should be level from side to side.

The video explains the basics.

If you have questions, please leave a comment, or go to the Submit Question page.

Hope you find it helpful.

And have you signed up for the RSS feed to get posts sent directly to you? Or our email delivery?

Measuring The Stern Pitch Of A Rowing Shell’s Rigger (Basic Rigging Video) is a post from: Max Rigging